![]() |
||||||
![]()
|
||||||
Size :
dimension:3x6cm(including pins) weight: 40g (including mainboard, current sensor, gps and wires) Features : THE new v1.5 CE OSD has two osd pattern, you can also switch the imperial and metric mode by pressing the setting button for 4seconds. The OSD requires 6.5-12.6v to operate. The power supply is connected to the camera/transmitter plugs on the OSD, so if you are using a 5V camera, the 5V power must bypass the OSD completely. If you have a 5V camera plugged in to the power connection on the OSD, and you plug the OSD into your main flight battery, you could damage your camera and your video transmitter. The OSD can be powered by your video system if the power jumper is in position 1-2. Make sure you cover up the exposed pins since they may have live power on them. If you want to power your video system from your main 3s flight battery, move the power jumper to 2-3 and the power from your main battery will power the OSD and will also be passed along to the video system wiring.
![]() ![]()
Important Considerations
1. Before taking off, in case the readings are not correct, press reset button to reset all parameters. (This operation will reset altitude, distance, timer, current and mAh consumed). 2.When OSD detect 0 voltage on the power battery, it will not display voltage, current and mAh consumed of power battery. 3. Return to Home: The return home on the screen indicates return home, when the home is in front of the plane, H will not flash; when home is behind the plane. H will flash; When H is in the middle and not flash, it indicates the plane is heading directly to home; When the H is in the middle and flash, it indicates the plane is flying 180 degree away from home; How to return to home: when H is on the left ,turn left; when the H is on the right, then turn right. 4.CEOSD will automatically detect video signal input and support both PAL and NSTC signal. 5.CEOSD heats up during working, which is normal. RSSI voltage display : CEOSD can display RSSI voltage RSSI voltage measuring range: 0.1-3.3V, when this voltage is below 0.1v, OSD will not display this parameter. How to use: Soldering two wires as indicated below to the RSSI port on the receiver. In case the OSD display switching cable is already connected with the receiver, only connect a RSSI voltage wire to the OSD, duplicated ground cable is not necessary.
|
|